Our 100% Silicone Patch and Repair Sealant is based on our High Solids Silicone formula. It is a much thicker material, more similar to a caulk than a roof coating, and is designed to be applied via trowel, putty knife, or brush.
Prep and repair seams, flashings, penetrations, and edges quickly and without mess with our easy-to-apply Patch and Repair Sealant. This product is a great tool to use before or after applying silicone to the field of the roof.
Available in: White, Gray, Black, and Clear, in 1-gallon pails, 2-gallon pails, and sausage tubes.
Application: Apply by hand with a brush, trowel, or putty knife.
Because the product is so thick, it can stand in place of traditional rubber, mesh, and polyester fabrics or tapes. Rather than laying down a roll of tape over separated seams, this product can be brush-applied over seams and around flashings much more quickly. Patch and Repair Sealant should be applied over the seam and then used in conjunction with our High Solids Silicone Roof Coatings.
On top of sealing seams, Patch and Repair Sealant is great for sealing flashings, joints, small cracks, fasteners, vents, uneven surfaces, protrusions, drains, and depressions.
Pro Patch is a must-have for any coating contractor, for both job prep and for any repairs or touch-up work after the job is complete.
Storage and Shelf Life: Pro Patch Silicone Sealant has a recommended shelf life of 12 months from the date of manufacture when stored in unopened containers between 40°F and 80°F. Refer to product packaging for date of manufacture.
Mix: Before applying our Patch and Repair Sealant, be sure to adequately mix the product.
Application: Apply this product by brush, trowel, putty knife, or roller. Make sure you force the product down into all penetrations and that you completely cover all protrusions.
Cure Time: Allow the first coat to cure for 3-12 hours, depending on environmental factors. As soon as it is cured, our Patch and Repair Sealant can be safely walked on. Apply silicone top coat of choice and continue coating the rest of the roof.
Weather Restrictions: To ensure optimum performance, it is recommended that you do not apply this product when surface temperatures are below 40 degrees. In cold-weather applications, material should be kept indoors and above 65°F until immediately before application. It is also recommended that you do not apply this material while rain is falling. Rain will not cause silicone to wash off, but the substrate will become wet and will negatively impact adhesion.
For more detailed application instructions, check out our installation specifications.